Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Farm & ranch
Before
After
Before
After
Before
AfterDoorKing Gate Access Control in Grand Prairie: What to Know First
DoorKing gate access control in Grand Prairie typically costs between $225 and $1,400 depending on whether you need a keypad repaired, a phone entry system replaced, or a full card reader and intercom setup installed. Most repairs are done same-day or next-day; most installations are scheduled within a few days of your call. As an independent DoorKing service provider, we’re not tied to the manufacturer’s warranty desk or their service queue – we diagnose the actual problem on your gate, fix what’s broken, and leave the rest alone.
If you own a DoorKing 1812, 9150, 6050, 1601, or a DK Pro series unit anywhere in Grand Prairie, this page is for you. Hal Gatewood has worked on DoorKing equipment across this city since 2001, and you can reach us at (903) 829-4499 any time. A live person answers – that’s Hal or one of his crew, not a recording.
Key Takeaways for DoorKing Owners in Grand Prairie
- DoorKing keypads and phone entry systems fail differently than other brands – usually from corrosion at the terminal block or a swollen backup battery, not the board itself.
- Most DoorKing gate access control repairs run $225 to $700; full system replacements with new wiring run $900 to $1,400.
- We fix DoorKing units in your driveway. We don’t haul your gate away, and we don’t sell you a new system if the old one can be made right.
- Every job carries our 90-Day Done Right Promise in writing. If it’s not right, one call brings us back.
- Free estimates. No overtime games. No surprise invoice at the door.
How DoorKing Products Fail - and How We Fix Them
We see the same handful of failures across DoorKing access control equipment in Grand Prairie, and most of them are not the circuit board. Here’s what actually shows up on these jobs:
- DoorKing 1812 keypads dead after storms. These apartment and small commercial keypads are everywhere in Grand Prairie, and the most common failure is a corroded terminal strip where the low-voltage wiring lands. The fix is usually solder-level repair and resealing the housing, not a new keypad. The 1812’s die-cast housing traps moisture here, and Grand Prairie’s clay soil holds water against the post, making it worse than most places.
- DoorKing 9150 slide gate operators with intermittent remote failure. The 9150’s external antenna wire comes loose from the receiver module over time, especially on gates that cycle more than 20 times a day. The remote works fine one minute and not the next. We re-secure the antenna, replace the receiver if it’s actually failed, and waterproof the connection. Most companies quote a whole new operator for this.
- DoorKing 6050 telephone entry systems that call, but won’t open. The 6050 is a solid unit, but the relay output contacts arc and weld themselves closed over time. When that happens, the visitor calls the homeowner, the homeowner presses 9, and nothing happens – or worse, the gate opens without a call. We replace the relay, not the board.
- DoorKing 1601 card readers that stop reading. The wired card readers on older 1601 installations fail when the EM card sensor drifts out of alignment after years of weather. It reads half the cards and fumbles the rest. We realign or replace the sensor head. A new reader costs less than a service visit from a company that swaps the whole controller.
- DoorKing DK Pro systems with dead backup batteries. The DK Pro line has a backup battery that swells in Texas heat inside enclosed enclosures. A swollen battery can deform the main board and cause total failure. We check the battery on every DoorKing access control job because it’s the cheapest thing to replace and the most expensive thing to ignore.
One thing that separates a real DoorKing tech from a parts-swapper: the 9150 and 6050 share certain relay modules, but the firmware loads differ between factory runs. We’re careful about matching the right revision to the right unit because we’ve seen mismatched modules cause gate behavior nobody can explain.
Our DoorKing Gate Access Control Process
When you call about a DoorKing unit, here’s exactly how the job goes:
- 1
You call (903) 829-4499. Hal or one of his crew answers. You describe the problem – “keypad lights up but gate won’t move” – and we schedule a visit that fits your day, not just ours.
- 2
We diagnose on site. Hal opens the enclosure, checks voltage, looks at wiring, tests the battery, and finds the actual failure. No guesswork over the phone, no “probably needs a board.” He’ll show you what he found and tell you what it needs. No runaround.
- 3
Parts decision. Some DoorKing parts work better from the factory – boards and relays mostly. Others, like keypad bezels and certain wire connectors, are better sourced as quality aftermarket replacements that hold up to Grand Prairie weather. We’ll tell you the difference and what it costs before we order anything.
- 4
The fix happens in your driveway. If welding is needed on the gate frame or post, we do it on site. No hauling, no downtime, no mystery charges for “shop time.”
- 5
Test everything. We’ll run the gate through full cycles, check entry codes, test remotes, verify the safety edges, and make sure the phone entry actually rings your cell. We don’t call a job done until we’ve watched it work the way it should.
- 6
You get the 90-Day Done Right Promise in writing. If anything we fixed isn’t right within 90 days, one call brings us back. No charge, no argument, no “that’s not covered.”
What DoorKing Gate Access Control Costs in Grand Prairie
Here’s what DoorKing work typically runs in the Grand Prairie area, based on the jobs we’ve done over the last few years:
- Keypad repair (DoorKing 1812 or similar): $225 to $450 – relay replacement, terminal cleaning and reseal, button repair
- Telephone entry system repair (DoorKing 6050): $300 to $550 – relay replacement, phone line check, speaker or microphone repair
- Card reader replacement (DoorKing 1601): $350 to $650 – sensor head replacement, reader alignment, wiring repair
- Full keypad and controller package (DoorKing 1812 with new harness): $700 to $1,100 – new unit, wiring, post condition repair if needed
- Complete phone entry system replacement (DoorKing 6050 equivalent with new wiring): $900 to $1,400 – new unit, new low-voltage wiring, surge protection
What moves the price is wire condition, post condition, and how much of the old hardware can be reused. We quote the full price up front, and that’s the price on the invoice. You’ll also get the standing offer: $40 off any repair over $200, and if you’re a senior or veteran, 10% off every job. Call (903) 829-4499 for an exact quote – estimates are free.
Why Grand Prairie Homeowners Call Gatewood Fence & Gate for DoorKing Work
We’ve been fixing gates in Grand Prairie since 2001, and we’ve been inside more DoorKing enclosures than we can count. Hal Gatewood learned the welding and mechanical side of this trade at Tarrant County College’s vocational program before going out on his own, and he’s been at it long enough to know that a gate sags in the hinge post, not in the middle – and that’s where we start.
Every job gets the 90-Day Done Right Promise in writing. If it’s not done right, we make it right – one call brings Hal back, no runaround. A live person answers our phone 24 hours a day, seven days a week, not a voicemail and not a call center three states away. You can drive to the shop and look Hal in the eye if you want to. The address is published, the license number is published, and Hal’s name is on the door.
And if your gate runs a LiftMaster, Mighty Mule, or Ghost Controls system instead of DoorKing, same story. We service those too, and eight other major brands besides. One phone number for all of it: (903) 829-4499.
Frequently Asked Questions
We’re an independent DoorKing service provider, so we don’t process manufacturer warranty claims directly. If your DoorKing unit is still under factory warranty, we’ll tell you what’s wrong and write it up so you can file the claim, or we’ll fix it ourselves if you’d rather have it done today. Many Grand Prairie homeowners choose to bypass the warranty after the first few weeks because the wait for a factory service call is usually longer than the repair itself.
Most DoorKing parts – relays, boards, keypads, card readers, phone modules – are available to us within 1 to 3 business days through our supply channels. Some older model parts take longer. If we’ve got the part on the truck, we’ll fix it the same day; if we have to order, we’ll tell you the delivery window before you spend a dime.
If your keypad is a DoorKing 1812 or 1814, repair is usually the better call – these units are built to be serviced, and a relay or terminal repair costs a fraction of a replacement. If it’s an older 1500-series unit with a failing main board, replacement starts to make more sense. We’ll tell you straight which way we’d go if it were our gate.
For access control failures that leave your gate inoperable or unsecured, we’re generally on site the same day or next morning. Grand Prairie is part of our regular service area, and we answer calls live around the clock – call (903) 829-4499 and we’ll give you a real arrival window.
Yes. We install and integrate video intercom, smart access, and remote control systems with existing DoorKing operators and controllers. The work includes the wireless bridge or network connection, the mobile app setup, and the full test – and it’s all covered by the same 90-Day Done Right Promise.
Call Gatewood Fence & Gate for DoorKing Gate Access Control in Grand Prairie
If your DoorKing keypad, phone entry, card reader, or intercom is acting up, don’t wait until it quits entirely and leaves you locked out or walking around a half-open gate. Call (903) 829-4499. Hal or one of his crew will answer, ask what it’s doing, and tell you what it needs. Estimates are free. The price you’re quoted is the price you pay. And if we miss something, the 90-Day Done Right Promise is in writing.
Written by Hal Gatewood, Owner, Gatewood Fence & Gate at Gatewood Fence & Gate, serving Grand Prairie and nearby areas.